2005 GMC Envoy Owner's Manual - Page 127

Reprogramming a Single HomeLink® Button To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps: 1. Press and hold the desired HomeLink® button. Do not release the button. 2. The indicator light will begin to flash after 20 seconds. While still holding the HomeLink® button, proceed with Step 2 under "Programming HomeLink® " shown earlier in this section. Storage Areas Glove Box Open the glove box by pulling the side of the handle towards the driver side. Overhead Console Your vehicle may have this feature. The overhead console may include a reading lamps, HomeLink® transmitter and a sunroof switch. See Sunroof on page 2-60 and HomeLink® Wireless Control System on page 2-49 for more information. If your vehicle has a third row seat, and has a power operated rear quarter glass, the switches for operating the rear quarter glass are also located in the overhead console. These switches allow the driver to open and close each third row seat window separately. Resetting Defaults To reset HomeLink® to default settings do the following: 1. Hold down the two outside buttons for about 20 seconds until the indicator light begins to flash. 2. Continue to hold both buttons until the HomeLink® indicator light turns off. 3. Release both buttons. For questions or comments, contact HomeLink® at 1-800-355-3515, or on the Internet at www.homelink.com. ) (Driver's Quarter Glass): Press button downward to open or upward to close the drivers side (left) quarter glass for the third row seat. ( (Passenger's Quarter Glass): Press button downward to open or upward to close the passengers side (right) quarter glass for the third row seat. 2-53