2011 Jeep Liberty Owner Manual - Page 241

UNDERSTANDING YOUR INSTRUMENT PANEL 239 • Right Rear Low Pressure (with a single chime). Refer scheduled oil change interval. The engine oil change to "Tire Pressure Monitoring System" in "Starting And indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon Operating". your personal driving style. • Check TPM System (with a single chime). Refer to "Tire Pressure Monitoring System" in "Starting And Unless reset, this message will continue to display each time you turn the ignition switch to the ON position. To Operating". turn off the message temporarily, press and release the • Check Gascap (refer to "Adding Fuel" in "Starting FUNCTION SELECT button. To reset the oil change And Operating" for more details) indicator system (after performing the scheduled maintenance), perform the following procedure: • Service Park Assist System (with a single chime) • Oil Change Required (with a single chime) • ECO (Fuel Saver Indicator) - if equipped 1. Turn the ignition switch to the ON position. Do not start the engine. 4 2. Fully depress the accelerator pedal slowly three times Oil Change Required within 10 seconds. Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message 3. Turn the ignition switch to the LOCK position. will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next