2008 Lexus RX 350 Owners Manual - Page 379

343

4-3. Do-it-yourself maintenance

4

■

When the initialization of the tire pressure warning system has failed

Initialization can be completed in a few minutes. However, in the following cases,

the settings have not been recorded and the system will not operate properly. If

repeated attempts to record tire inflation pressure settings are unsuccessful, have

the vehicle inspected by your Lexus dealer.

●

When operating the tire pressure warning reset switch, the tire pressure warning

light does not flash 3 times.

●

After driving for a certain period of time since the initialization has been com-

pleted, the tire pressure warning light comes on after blinking for 1 minute.

■

Routine tire inflation pressure checks

The tire pressure warning system does not replace routine tire inflation pressure

checks. Make sure to check tire inflation pressure as part of your routine of daily

vehicle checks.

■

Tire pressure warning system certification

For vehicles sold in the U.S.A.

NOTE:

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-

lowing two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

NOTICE:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful inter-

ference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

●

Reorient or relocate the receiving antenna.

●

Increase the separation between the equipment and receiver.

●

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

●

Consult the dealer or an experienced radio/TV technician for help.