2001 Lincoln Navigator Owner Guide 4th Printing - Page 46

Controls and features Fan speed ( ) When AUTOMATIC is pressed, fan speed is adjusted automatically for existing conditions. You can override fan speed at any time. To control fan speed manually, use the thumbwheel or steering wheel control to cancel automatic fan speed operation. OFF HI AUTOMATIC FLR • DEF DEF LO • Rotate the thumbwheel up for higher fan speed or down for lower fan speed. • Press the steering wheel control up for higher fan speed or down for lower fan speed. The display will show to ˚F indicate manual fan operation. AUTO To return to automatic fan operation, press AUTOMATIC. Manual override controls The override controls are located at the bottom of the EATC and allow you to determine where airflow is directed. To return to full automatic control, press AUTOMATIC. F OFF HI OUTSIDE TEMP AUTO AUTOMATIC MAX A/C VENT PNL • FLR FLOOR FLR • DEF DEF LO The air conditioning compressor can operate in all modes except FLOOR and VENT. It will also operate only when required when AUTOMATIC has been selected. However, the air conditioning will only function if the outside temperature is about 6°C (43°F) or higher. Since the air conditioner removes considerable moisture from the air during operation, it is normal if clear water drips on the ground under the air conditioner drain while the system is working and even after you have stopped the vehicle. Under normal conditions, your vehicle's climate control system should be left in any position other than MAX A/C or OFF when the vehicle is parked. This allows the vehicle to "breathe" through the outside air inlet duct. 46