2003 Lincoln Navigator Quick Reference Guide 2nd Printing - Page 9

18236 Navigator_REV_g.qxd 10/5/03 11:55 AM Page 9 8 Rear Window Defroster 11 Speed Control To operate, the speed control must be ON and the vehicle speed must be greater than 30 mph (48 km/h). Once the system is engaged, an icon will illuminate. To set a speed, press SET +. To set a higher speed, press SET + again. To set a lower speed, press SET -. Pressing RES will return to a previously set speed. To disengage the speed control without erasing the previously programmed set speed, press CNCL or depress the brake pedal. To turn the speed control off, press the OFF button or turn off the ignition. g Press to activate rear window defrost. The rear defrost indicator will illuminate. When in operation, the rear window defroster also defrosts the side view mirrors. The rear window defroster will automatically turn off after approximately 10 minutes of operation. Press the control again to re-engage if needed. 9 Control-Trac Four-Wheel Drive Control (if equipped) n r 2H (2WD HIGH) delivers power to the rear wheels only and is the optimal position for smoothness and fuel economy. A4WD (4X4 AUTO) automatically delivers power to all four wheels, as required, for increased traction. 4H (4X4 HIGH) provides mechanically locked four-wheel drive power to all four wheels. 4L (4X4 LOW) provides mechanically locked four-wheel drive when extra power at reduced speeds is required. To shift from 2H to A4WD or 4H, move the control at any forward speed up to 55 mph (88 km/h). To shift from A4WD to 4H, move the control at a stop or while driving at any speed. To shift to or from 4L, bring the vehicle to a stop and keep the brake pedal depressed. Next, place the gearshift in N (Neutral), and then move the control to 4L. When shifting from one four-wheel drive position to the next, a mechanical noise may be heard. This is normal and no service should be required. 12 Hood Release Pull the hood release handle. Next, release the auxiliary latch with the handle located under the front of the hood, just above the passenger-side headlamp. Slide the yellow handle away from the center of the vehicle to release the auxiliary latch. Lift the hood until the lift cylinders hold it open. 13 Parking Brake with Auto-Release To release the parking brake using the automatic release feature, turn the ignition to the ON position and then press the brake pedal. Move the gearshift out of the P (Park) position with the brake pedal depressed. If the parking brake fails to release after this procedure is completed, pull the manual parking brake release lever to release the brake. To set the parking brake, press the parking brake pedal down until the pedal stops. The BRAKE warning lamp in the instrument cluster will illuminate (when the ignition is turned ON) until the parking brake is released. 10 Power Adjustable Foot Pedals Press and hold the rocker control to adjust the accelerator and brake pedal toward you or away from you. Adjust the pedals only when the vehicle is stopped and the gearshift lever is in the P (Park) position. e