2011 Lincoln Town Car Owner Guide 2nd Printing - Page 51

Lights 4. Remove the three screws and protective bulb cover from the headlamp assembly. 5. Rotate the bulb socket counterclockwise and remove from lamp assembly. 6. Carefully pull bulb straight out of the socket and push in the new bulb until it snaps, locking it into position. 7. To complete installation, follow the removal procedure in reverse order. Note: To ensure a good seal, attach the bulb cover and partially tighten the screws. Check to ensure the gasket is fully centered. Finish tightening the screws in a criss-cross pattern (upper-left, lower right etc.) Replacing tail lamp/brake/turn lamp bulbs The tail lamp, the brake lamp and the turn signal lamp bulbs are located in the tail lamp assembly. Follow the same steps to replace these bulbs. 1. Make sure the headlamp switch is in the off position, then open the trunk and remove the retainer. 2. Carefully pull the carpet away to expose the lamp assembly hardware. 3. Remove the three nut and washer assemblies, then pull the lamp assembly away from the vehicle. 51 2011 Town Car (tow) Owners Guide, 2nd Printing USA (fus)