2007 Mercury Mountaineer Owner Guide 2nd Printing - Page 133

Locks and Security Switching from two step to one step door unlocking Your vehicle comes with two step unlocking enabled. Unlocking can be switched between two step and one step door unlocking by pressing and holding both the and buttons simultaneously on the remote entry transmitter for approximately 4 seconds. The parklamps will flash twice to indicate that the vehicle has switched to one step unlocking. Repeat the procedure to switch back to two-step unlocking. Locking the doors/liftgate 1. Press and release to lock all the doors and liftgate. The lamps will flash. Note: If any door, the liftgate or the liftgate glass are not closed properly, the lamps will not flash. 2. Press and release again within three seconds to confirm that all the doors are closed and locked. Note: The doors will lock again, the horn will chirp and the lamps flash once. Note: If any door, the liftgate or the liftgate glass are not closed properly, the horn will make two quick chirps. Opening the liftgate window Press to unlatch the liftgate window. Sounding a panic alarm Press to activate the alarm. The horn will sound and the parklamps will flash for a maximum of 3 minutes. Press again or turn the ignition to the 3 (ON) position to deactivate, or wait for the alarm to timeout in 3 minutes. Note: The panic alarm will only operate when the ignition is in the 1 (OFF/LOCK) position . Memory seats/adjustable pedals/easy entry-exit feature (if equipped) The remote entry system can also control the memory seat /adjustable pedals/easy entry-exit feature. Press to automatically move the seat and adjustable pedals to the desired memory position (the seat position corresponds to the transmitter being used). Activating the memory seat feature To activate this feature: 1. Position the seat and adjustable pedals to the position desired. 133 2007 Mountaineer (mnt) Owners Guide (post-2002-fmt) USA (fus)