1998 Nissan Altima Owner's Manual - Page 133

● Do not use oil or grease on the wheel studs or nuts. This could cause the nuts to become loose. As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench. Wheel nut tightening torque: 72 to 87 ft-lb (98 to 118 N⅐m) CE1030 CE1082 Adjust tire pressure to the COLD pressure. COLD pressure: After vehicle has been parked for three hours or more or driven less than 1 mile (1.6 km). COLD tire pressures are shown on the tire placard affixed to the driver's door, center pillar. ● Retighten the wheel nuts when the vehicle has been run for 600 miles (1,000 km). 5. With the spare tire installed on the vehicle, place the damaged tire in the spare tire storage area. Put the jack rod and wheel nut wrench in the tool bag and Installing the spare tire The T-type spare tire is designed for emergency use. See specific instructions under the heading ''Wheels and tires'' in the ''Do-it-yourself'' section. 1. Clean any mud or dirt from the surface between the wheel and hub. 2. Carefully put the spare tire on and install the wheel nuts finger-tight. 3. With the wheel nut wrench, tighten wheel nuts alternately and evenly until they are tight. 4. Lower the vehicle slowly until the tire touches the ground. Then, with the wheel nut wrench, tighten the wheel nuts securely in the sequence as illustrated. Lower the vehicle completely. WARNING ● Incorrect wheel nuts or improperly tightened wheel nuts can cause the wheel to become loose or come off. This could cause an accident. 6-6 In case of emergency