2002 Nissan Frontier Owner's Manual - Page 155
2002 Nissan Frontier Manual
Page 155 highlights
COAST/SET, or CANCEL switch (located on the steering wheel). To properly use the cruise control system, use the following procedures. WARNING Do not use the cruise control when driving under the following conditions. ● When it is not possible to keep the vehicle at a set speed. ● In heavy traffic or in traffic that varies in speed. ● On winding or hilly roads. ● On slippery roads (rain, snow, ice, etc.). ● In very windy areas. Doing so could cause a loss of vehicle control and result in an accident. CAUTION On manual transmission models, do not shift into N (Neutral) without depressing the clutch pedal when the cruise control is set. Should this occur, depress the clutch pedal and turn themain switch off immediately. Failure to do so may cause engine damage. CRUISE CONTROL OPERATIONS The cruise control allows driving at a speed between 25 to 90 MPH (40 to 144 km/h) without keeping your foot on the accelerator pedal. To turn on the cruise control, push the main switch. The CRUISE indicator light in the instrument panel comes on. To set cruising speed, accelerate the vehicle to the desired speed, push the COAST/SET switch and release it. The SET light in the instrument cluster comes on. Take your foot off the accelerator pedal. Your vehicle maintains the set speed. ● To pass another vehicle, depress the accelerator pedal. When you release the pedal, the vehicle returns to the previously set speed. ● The vehicle may not maintain the set speed when going up or down steep hills. If this happens, drive without the cruise control. To cancel the preset speed, use one of the following three methods: a) Push the CANCEL button; the SET light in the instrument cluster goes out. b) Tap the brake pedal; the SET light goes out. c) Turn the main switch off. Both the CRUISE indicator on the main switch and SET light in the instrument cluster go out. The cruise control is automatically cancelled and the SET light in the instrument panel goes out if: ● you depress the brake or clutch pedal while pushing the RES/ACCEL or COAST/SET switch. ● the vehicle slows down more than 8 MPH (13 km/h) below the set speed. ● you depress the clutch pedal (manual transmission), or move the shift selector lever to N (Neutral) (automatic transmission). To reset at a faster cruising speed, use one of the following three methods. a) Depress the accelerator pedal. When the vehicle attains the desired speed, push and release the COAST/SET switch. b) Push and hold the RES/ACCEL switch. When the vehicle attains the speed you desire, release the switch. 5-18 Starting and driving