2007 Nissan Pathfinder Owner's Manual - Page 108
2007 Nissan Pathfinder Manual
Page 108 highlights
POWER OUTLET ● the 4WD switch must be in the 4H position and the vehicle speed must be under 21 mph (35 km/h), and ● the hill descent control system switch must be ON. The hill descent control indicator light will come on when the system is activated. Also, the stop/tail lights illuminate while the hill descent control system applies the brakes to control vehicle speed. If the accelerator or brake pedal is depressed while the hill descent control system is on, the system will stop operating temporarily. As soon as the accelerator or brake pedal is released, the hill descent control system begins to function again if the hill descent control operating conditions are fulfilled. The hill descent control indicator light blinks if the switch is on and all conditions for system activation are not met or if the system becomes disengaged for any reason. To turn off the hill descent control system, push the switch to the OFF position. For additional information, see "Hill descent control system on indicator light" earlier in this section and "Hill descent control system" in the "Starting and driving" section of this manual. LIC0760 LIC0761 Front row The power outlets are for powering electrical accessories such as cellular telephones. The bottom power outlet located on instrument panel and the power outlet located in the cargo area are powered directly by the vehicle's battery. The top power outlet (if so equipped)located on the instrument panel and the power outlet located inside the center console are powered only when the ignition key is in the ACC or ON position. Open the cap to use a power outlet. Center console CAUTION ● The outlet and plug may be hot during or immediately after use. ● Only certain power outlets are designed for use with a cigarette lighter unit. Do not use any other power outlet for an accessory lighter. See your NISSAN dealer for additional information. ● Do not use with accessories that exceed a 12 volt, 120W (10A) power draw. Do not use double adapters or more than one electrical accessory. 2-34 Instruments and controls