2008 Nissan Maxima Owner's Manual - Page 146

Selecting the memorized position Set the CVT selector lever to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) fully for at least 1 second, or ● Turn the ignition switch to the ON position and push the memory switch (1 or 2) fully for at least 1 second. The driver's seat, steering column, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. The driver's seat and steering wheel will return to previous position when the driver's door is closed and the ignition switch is pushed The entry/exit function can be adjusted or canceled. See "Vehicle electronic systems" in the "Display screen, heater, air conditioner, audio and phone systems" section of this manual. ● When any of the memory switches are pushed while the automatic drive positioner is operating. ● When the adjusting switch for the driver's seat is turned on while the automatic drive positioner is operating. ● When the memory switch (1 or 2) is not pushed and held for at least 1 second. ● When the seat has been already moved to the memorized position. ● When no seat position is stored in the memory switch. ● When the CVT selector lever is moved from P (Park) to any other position. ● When the driver's door remains open more than 45 seconds and the ignition switch is not in the ON position. The automatic drive positioner system can be adjusted and canceled for vehicles with navigation system. See "Vehicle electronic systems" in the "Display screen, heater, air conditioner, audio and phone systems" section of this manual. Restarting the entry/exit function If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition key in the LOCK position. The entry/exit function should now work properly. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat and automatic operation steering column (if so equipped) will automatically move when the CVT selector lever is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward and the steering wheel will move up when the driver's door is opened and the ignition switch is in the LOCK position. SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h). 3-30 Pre-driving checks and adjustments