2009 Nissan Rogue Owner's Manual - Page 291

INSTALLING FRONT LICENSE PLATE Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag...License plate bracket J-nut 6 2 Screw 6 2 Screw grommet 6 2 1. Temporarily place the license plate bracket A by aligning the lower part * of it with the B lines * on the bumper. 2. Mark the pilot hole points with a felt-tip pen through the holes of the license plate bracket. 3. Remove the license plate bracket. 4. Carefully drill two pilot holes using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) 5. Insert grommets into the hole on the fascia. 6. Insert a flat-blade screwdriver into the grommet hole to add 908 turn onto the part C *. Technical and consumer information 9-11 STI0599