2013 Nissan Xterra Navigation System Owner's Manual - Page 93

2013 Nissan Xterra Manual

Get 2013 Nissan Xterra PDF manuals and user guides View all 2013 Nissan Xterra manuals

Page 93 highlights

● If waypoints are set, the system calculates multiple routes between waypoints simultaneously, and the following may result. - If one section between waypoints cannot be calculated, none of the route will be displayed. - The route may not connect completely at some waypoints. - The route may require a U-turn close to some waypoints. ● Route calculation may not be completed in the following cases. - If there is no main road within a range of 1.5 miles (2.5 km) from the vehicle, a message will then appear on the screen. Try recalculating when the vehicle is closer to a main road. - If the vehicle is too close to the destination or if there are no roads to the destination, a message will then appear on the screen. - If it is impossible to reach the destination or waypoints because of traffic regulations, etc. - If the only target route to the destination or waypoints is extremely complicated. ● The following may occur when the route is displayed. - If you calculate a route on a main road, the starting point of the route may not exactly match the current vehicle location. - The endpoint of the route may not exactly match the destination. - If you calculate a route on a main road, the system may display a route from another main road. This may be because the position of the vehicle icon is not accurate. In this case, park the vehicle in a safe location and reset the vehicle icon, or continue driving to see if the position of the vehicle icon is automatically adjusted before recalculating the route. "VEHICLE ICON" (page 7-3) - In some cases, the system shows an indirect route to the destination or waypoints if you set them from stored or places information. In order to correct, you must be careful about the traffic direction, especially when lanes with different travel directions are shown separately, such as interchanges and service areas. - Even if the freeway preference is set to OFF, a route that uses the freeway may be suggested. - Even if the preference is set to OFF, a route that uses a ferry line may be suggested. - Ferry lines, excluding those that are only for pedestrians, bicycles and motorcycles, are stored in this system. Take into consideration the travel time required and operational condition before deciding whether to use the route. General system information 6-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
●
If waypoints are set, the system calculates
multiple
routes
between
waypoints
simultaneously,andthefollowingmayresult.
– Ifonesectionbetweenwaypointscannot
be calculated, none of the route will be
displayed.
– Theroutemaynotconnectcompletelyat
somewaypoints.
– The route may require a U-turn close to
somewaypoints.
●
Route calculation may not be completed in
thefollowingcases.
– Ifthereisnomainroadwithinarangeof
1.5 miles (2.5 km) from the vehicle, a
messagewillthenappearonthescreen.
Try recalculating when the vehicle is
closertoamainroad.
– If the vehicle is too close to the destina-
tion or if there are no roads to the
destination, a message will then appear
onthescreen.
– Ifitisimpossibletoreachthedestination
or
waypoints
because
of
traffic
regulations,etc.
– If the only target route to the destination
orwaypointsisextremelycomplicated.
●
The following may occur when the route is
displayed.
– If you calculate a route on a main road,
thestartingpointoftheroutemaynotex-
actlymatchthecurrentvehiclelocation.
– Theendpointoftheroutemaynotexactly
matchthedestination.
– If you calculate a route on a main road,
the system may display a route from an-
other main road. This may be because
the position of the vehicle icon is not
accurate.Inthiscase,parkthevehiclein
asafelocationandresetthevehicleicon,
or continue driving to see if the position
of the vehicle icon is automatically ad-
justedbeforerecalculatingtheroute.
“VEHICLEICON”(page7-3)
– In some cases, the system shows an in-
direct route to the destination or way-
points if you set them from stored or
places information. In order to correct,
you must be careful about the traffic
direction,especiallywhenlaneswithdif-
ferent travel directions are shown
separately, such as interchanges and
serviceareas.
– Even if the freeway preference is set to
OFF, a route that uses the freeway may
besuggested.
– Even if the preference is set to OFF, a
route that uses a ferry line may be
suggested.
– Ferry lines, excluding those that are only
for
pedestrians,
bicycles
and
motorcycles, are stored in this system.
Takeintoconsiderationthetraveltimere-
quired and operational condition before
decidingwhethertousetheroute.
Generalsysteminformation
6-5