2014 Nissan Pathfinder Quick Reference Guide - Page 28

system guide  For optimum performance, select the appropriate headphone channel 05 that corresponds to the headrest display being viewed directly in front of you.  To watch or control videos on the front display make sure the vehicle is in the P (PARK) position and the parking brake is applied.  To reduce driver distraction, the wireless headphones will not operate while located in the front seats and movies will not be shown on the front display while the vehicle is in any drive position.  To access standard DVD controls on the front display while playing a DVD on the rear display, press the DISC•AUX button on the audio control panel while the vehicle is in the P (Park) position and the parking brake is applied. For more information, refer to the "Monitor, climate, audio, phone and voice recognition systems (section 4)" of your Owner's Manual. 05 HOMELINK® UNIVERSAL TRANSCEIVER (if so equipped)  The HomeLink system can learn and consolidate the functions of up to 3 different hand-held transmitters, operating items such as garage doors, property gates, outdoor and indoor lights or alarm systems.  To program the HomeLink Universal Transceiver: • Position the handheld transceiver 1-3 in (26-76 mm) away from the HomeLink surface, keeping the HomeLink indicator light in view. • Press and hold the desired HomeLink button and the handheld transmitter button simultaneously until the HomeLink indicator light flashes slowly and then rapidly. • Both buttons may be released when the indicator light flashes rapidly. HOMELINK  To verify the programing is complete, press and hold the HomeLink and observe the indicator light A solid continuous light indicates the programing is complete and the HomeLink button will activate your device. • A blinking light that turns to a solid continuous light after 2 seconds indicates additional steps are required to complete the programing.  An additional person may make the remaining steps easier. To complete the programing process: • At the receiver of the device that you are programing to the HomeLink, press and release the "learn" or "smart" button (the name may vary by manufacturer but it is usually located near where the hanging antenna wire is attached to the unit). You have approximately 30 seconds to initiate the following step. • Press and hold the programmed HomeLink button for 2 seconds and release.  Repeat the previous 2 steps up to 3 times to complete the programming process. HomeLink should now activate your device. For more information, refer to the "Instruments and controls (section 2)" of your Owner's Manual, the HomeLink website at www.homelink.com or call 1-800-355-3515. 26 To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.