2015 Nissan Pathfinder Owner's Manual - Page 195

The selected mirror surface will return to its original position when any of the following have occurred: ● The shift lever is moved to any position other than R (Reverse). ● The outside mirror control switch is set to the neutral or center position. ● The ignition switch is placed in the OFF position. NOTE: If the outside mirror control switch is in the neutral position, neither mirror will turn downward when the shift lever is moved to R (Reverse). not be adjusted for the driving position. Note that the function is set to disabled as the factory default setting. The seat synchronization function operates under the following conditions: ● The ignition switch is in the ON position. ● The shift lever is in the P (Park) position. If the outside mirrors or the steering wheel reaches its maximum adjustment, the function is automatically disabled. Restart the function by selecting a previously stored seat memory position using the memory switches (1 or 2). An Intelligent Key that was previously linked to the stored seat memory can also be used to restart the function. If a seat position was not previously stored in the seat memory, restart the function by adjusting the steering wheel and outside mirrors manually for your best driving position and then drive the vehicle above 4 MPH (7 km/h). Cancel or activate seat synchronization function The shift lever must be in the P (Park) position with the ignition switch placed in the ACC position. Confirming memory storage ● Place the ignition switch in the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. ● If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again. Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition switch in the LOCK position. Once the memory storage function has been restarted, you can store a memory position. For additional information, refer to "Memory storage function" in this section. Seat synchronization function The seat synchronization function automatically adjusts the positions of the steering wheel and outside mirrors when the seat is adjusted using the power seat switches. However, the steering wheel and outside mirrors will not move if the seat is adjusted over the maximum thresholds. The system considers that the steering wheel and outside mirror adjustments are not necessary because the seat may 3-38 Pre-driving checks and adjustments