2003 Saab 9-3 Owner's Manual - Page 113
2003 Saab 9-3 Manual
Page 113 highlights
Interior equipment The LED will flash slowly at first and then rapidly. The rapidly flashing LED indicates that programming is complete and that you can release the buttons. Complete erase Completely erase the memory of the garage opener by pressing and holding buttons 1 and 3 simultaneously for 20 seconds. Confirmation is provided by the LED flashing rapidly for 10 seconds. A complete erase deletes the frequencies from all three buttons. It is not possible to erase the memory of a single button. Opening a garage door Press and hold the appropriate button until the garage door starts to open. You can of course still use your original garage door opener even if you have programmed the garage opener in the rearview mirror. 113 Garage doors with rolling security codes Garage doors with rolling security codes manufactured after 1996 can be identified as follows: • Read the instruction manual for the garage door. • Programming the garage opener in the rearview mirror seems to be successful but the garage door does not open. • Press and hold the programmed button. The garage door uses a rolling security code if the LED flashes rapidly and after 2 seconds shines constantly. If the garage door remote control uses rolling security codes, proceed as follows having programmed the garage opener: 1 Localise the button labelled "learn" or "smart" on the motor unit of the garage door. The location and color of this button varies between makes. 2 Press and release the "learn" button on the motor unit. Step 3 must be performed within 30 seconds of Step 2. 3 Press the programmed button on the rearview mirror twice (some garage doors require the button to be pressed three times; refer to the door's instruction manual). NOTICE Switch off the power supply to the garage door or gate (or park the car beyond the range of the remote control) while programming using the "cycling" method to prevent damaging the electrical motor. Reprogramming a button that has previously been programmed 1 Press and hold the desired button on the rearview mirror for the entire programming sequence. 2 The LED will start to flash slowly after 20 seconds. 3 Hold your existing garage door opener 1-3 in. (3-7 cm) from the rearview mirror and press the button on the remote control. 4 Reprogramming is complete when the LED starts to flash rapidly. The previous frequency is now erased and replaced by the new one. Reprogramming one button does not affect the other buttons.