2004 Subaru Legacy Owner's Manual - Page 233
2004 Subaru Legacy Manual
Page 233 highlights
Audio wish to listen. Weather band button (WB) Press the "WB" button (2) to choose weather band. The display will show WB. Use the tuning dial to select the station to which you wish to listen. Manual tuning Turn the tuning dial (3) outer tuner to increase or decrease the reception frequency in individual steps. FM band: 0.2 MHz steps AM band: 10 kHz steps Weather band: 1 step (1 channel) Seek tuning (SEEK) If the Tuning dial (3) outer tuner is turned for longer than half of a second, the radio will begin to automatically search for receivable frequencies and will stop at the first one found. This function may not be available, however, when radio signals are weak. In such a situation, perform manual tuning to select the desired station. Scan tuning (SCAN) Press the "SCAN" button (4) to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop 5-32 at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned. Turn the tuning dial (3) inner tuner again to cancel the SCAN mode and to stop on any displayed frequency. Scan tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills. Preset tuning Press any one of the preset buttons (5) to select the corresponding, previously-registered radio station. The LED at the top of that button will turn on. Manual preset Use the tuning dial (3) to select the radio station which you wish to register. Choose the preset button (5) to which you wish to assign that station and press it continuously for a period of more than 2 seconds. When the radio station has been successfully registered, the display will flash the corresponding radio frequency on and off once. NOTE Each preset button can be used to store both an FM station and an AM station. If the power supply is interrupted by disconnection of the battery, memory presets will be cleared