2006 Subaru Impreza Owner's Manual - Page 140
2006 Subaru Impreza Manual
Page 140 highlights
Use clean water if windshield washer fluid is unavailable. In areas where water freezes in winter, use SUBARU Windshield Washer Fluid or the equivalent. (See the Windshield washer fluid section in chapter 11.) Also, when driving the vehicle when there are freezing temperatures, use non-freezing type wiper blades. NOTE Do not clean the wiper blades with gasoline or a solvent, such as paint thinner or benzene. This will cause deterioration of the wiper blades. The wiper operates only when the ignition switch is in the ON or ACC position. Clean your wiper blades and window glass periodically with a washer solution to prevent streaking, and to remove accumulations of road salt or road film. Keep the washer button depressed at least for 1 second so that washer solution will be sprinkled all over the windshield or rear window. Grease, wax, insects or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove those streaks after operating the washer or if the wiper operation is jerky, clean the outer surface of the windshield or rear window and the wiper blades using a sponge or soft cloth with a neutral detergent or mild-abrasive cleaner. After cleaning, rinse the window glass and wiper blades with clean water. The glass is clean if no beads form on the glass when you rinse with water. If you cannot eliminate the streaking even after following this procedure, replace the wiper blades with new ones. Refer to the Replacement of wiper blades section (chapter 11) for replacement instructions. Windshield wiper and washer switches Windshield wipers OFF Instruments and controls 3-27 LO HI To turn the wipers on, push the wiper control lever down. To turn the wipers off, return the lever to the OFF position. OFF: Park : Intermittent LO: Low speed HI: High speed 300137 CONTINUED