2012 Subaru Tribeca Owner's Manual - Page 529

11-40 Maintenance and service the rear combination light assembly rearward and remove it from the vehicle. & Back-up light/Tail light 1) 2) Brake/tail light Rear turn signal light 3. Remove the bulb holder from the rear combination light assembly by turning it counterclockwise. 4. Remove the bulb from the socket by pushing it and turning counterclockwise. 5. Install a new bulb. 6. Set the bulb holder into the rear combination light assembly and turn it clockwise until it locks. 7. Reinstall the rear combination light assembly by sliding the two-pronged part of the combination light assembly securely to each holder of the vehicle side. 8. Tighten the two mounting screws, and then close the covers. 1. Use a flat-head screwdriver to remove the light cover from the rear gate trim. 1) 2) Tail light Back-up light