3Com 4250T Getting Started Guide - Page 54
Solving Problems Indicated by LEDs, The Power LED does not light, On powering-up
UPC - 662705440347
View all 3Com 4250T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
54 CHAPTER 4: PROBLEM SOLVING Solving Problems Indicated by LEDs If the LEDs on the Switch indicate a problem, refer to the list of suggested solutions below. The Power LED does not light Check that the power cable is firmly connected to the Switch and to the supply outlet. If the connection is secure and there is still no power, you may have a faulty power cord or an internal fault. Firstly, check the power cord by: ■ testing it in another device ■ connecting a working power cord to the 'problem' device then contact your supplier for advice. On powering-up, the Power/Self Test LED lights yellow The Switch unit has failed its Power On Self Test (POST) because of an internal problem. If a port has failed it's POST, it's LED will flash green/yellow alternately to indicate that the port is disabled. Contact your supplier for advice. A link is connected and yet the Status LED for the port does not light Check that: ■ The Switch and the device at the other end of the link (or cable) are connected securely. ■ The devices at both ends of the link are powered-up ■ The quality of cable is satisfactory ■ Auto-negotiation settings are the same at both ends. Auto-negotiation problems will occur with all ports where auto-negotiation is disabled and incorrect cables are being used (cross-over or straight).