ASRock 4Core1600-D800 Quick Installation Guide - Page 15
Onboard Headers and Connectors, English
View all ASRock 4Core1600-D800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! FDD connector (33-pin FLOPPY1) (see p.2 No. 20) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 7) connect the blue end to the motherboard connect the black end to the IDE devices 80-conductor ATA 66/100 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors (SATAII_1: see p.2, No. 14) (SATAII_2: see p.2, No. 12) (SATAII_3: see p.2, No. 13) (SATAII_4: see p.2, No. 11) SATAII_3 SATAII_1 Serial ATA (SATA) Data Cable (Optional) SATAII_4 SATAII_2 These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. Either end of the SATA data cable can be connected to the SATA / SATAII hard disk or the SATAII connector on this motherboard. Serial ATA (SATA) Power Cable (Optional) connect to the SATA HDD power connector connect to the power Please connect the black end of SATA power cable to the power connector on each drive. Then connect the white end of SATA power cable to the power connector of the power supply. 15 ASRock 4Core1600-D800 Motherboard English