ASRock 880G Pro3 Quick Installation Guide - Page 29
HDLED Hard Drive Activity LED
View all ASRock 880G Pro3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
HDLED (Hard Drive Activity LED): Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assign-ments are matched correctly. Power LED Header (3-pin PLED1) (see p.2 No. 21) Chassis Speaker Header (4-pin SPEAKER 1) (see p.2 No. 20) Please connect the chassis power LED to this header to indicate system power status. The LED is on when the system is operating. The LED keeps blinking in S1 state. The LED is off in S3/S4 state or S5 state (power off). Please connect the chassis speaker to this header. Chassis and Power Fan Connectors (4-pin CHA_FAN1) (see p.2 No. 40) (3-pin CHA_FAN2) (see p.2 No. 7) Please connect the fan cables to the fan connectors and match the black wire to the ground pin. CHA_FAN1/2/3 fan speed can be controlled through UEFI or AXTU utility. (3-pin CHA_FAN3) (see p.2 No. 12) (3-pin PWR_FAN1) (see p.2 No. 2) CPU Fan Connectors (4-pin CPU_FAN1) (see p.2 No. 6) 1 2 3 4 Please connect the CPU fan cable to the connector and match the black wire to the ground pin. English 29 ASRock 880G Pro3 Motherboard