ASRock Fatal1ty Z68 Professional Gen3 User Manual - Page 39
Onboard Headers and Connectors
View all ASRock Fatal1ty Z68 Professional Gen3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
2.11 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! FDD connector (33-pin FLOPPY1) (see p.15 No. 31) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Black) (39-pin IDE1, see p.15 No. 8) connect the blue end connect the black end to the motherboard to the IDE devices 80-conductor ATA 66/100/133 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATAII Connectors (SATA2_2_3: see p.15, No. 13) (SATA2_4_5: see p.15, No. 12) These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. SATA2_2_3 SATA2_4_5 Serial ATA3 Connectors (SATA3_0_1: see p.15, No. 14) (SATA3_A1_A2: see p.15, No. 15) (SATA3_A3_A4: see p.15, No. 16) These six Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate. If you install the HDD on the eSATA port on the rear I/O, the internal SATA3_A4 will not function. SATA3_A3_A4 SATA3_A1_A2 SATA3_0_1 39