ASRock Q1900DC-ITX User Manual - Page 12
Audio Output, Channels, Front Speaker, No. 8, Rear Speaker, Central / Bass, No. 10, Side Speaker
View all ASRock Q1900DC-ITX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
** If you use a 2-channel speaker, please connect the speaker's plug into "Front Speaker Jack". See the table below for connection details in accordance with the type of speaker you use. Audio Output Channels 2 4 6 8 Front Speaker (No. 8) V V V V Rear Speaker (No. 6) -V V V Central / Bass (No. 10) --V V Side Speaker (No. 5) ---V To enable Multi-Streaming, you need to connect a front panel audio cable to the front panel audio header. After restarting your computer, you will find the "Mixer" tool on your system. Please select "Mixer ToolBox" , click "Enable playback multi-streaming", and click "ok". Choose "2CH", "4CH", "6CH", or "8CH" and then you are allowed to select "Realtek HDA Primary output" to use the Rear Speaker, Central/Bass, and Front Speaker, or select "Realtek HDA Audio 2nd output" to use the front panel audio. *** Please use a 9~19V power adapter for the DC jack. This jack accepts dual barrel plugs with an inner diameter of 2.5 mm and an outer diameter of 5.5 mm, where the inner contact is +19V (±10%) DC and the shell is GND. 5.5 mm Please refer to below hardware configuration for the estimated adapter power. 2.5 mm DRAM 1 1 2 HDD 1 2 4 Estimated Adapter Power 30W 45W 79W Due to the power limitation and PCIe bandwidth (x1), the VGA card is not supported. When you use the DC-in power adapter, please use the onboard SATA power connector to get the power for HDDs. English 8