ASRock Z790 PG Lightning Software/BIOS Setup Guide - Page 52
MRC Training on Warm Boot, ODT CK B1 Group B
View all ASRock Z790 PG Lightning manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
ODT CK (B1 Group B) Configure the memory on die termination resistors' CK. Configuration options: [Auto] [40] [60] [80] [120] [240] [480] [Disabled] ODT CK (B2 Group B) Configure the memory on die termination resistors' CK. Configuration options: [Auto] [40] [60] [80] [120] [240] [480] [Disabled] Advanced Setting ASRock Timing Optimization Enable/Disable ASRock Timing Optimization. When enabled, the memory timing will use ASRock optimized value. Configuration options: [Enabled] [Disabled] ASRock DRAM Frequency Optimization Enable/Disable ASRock DRAM Frequency Optimization. When enabled, the DRAM Frequency will run ASRock optimized procedure. Configuration options: [Auto] [Enabled] [Disabled] MRC Training Respond Time Configure the MRC Training Respond Time. Configuration options: [Auto] [Slowest] Realtime Memory Timing Enable/Disable realtime memory timings. When enabled, the system will allow performing realtime memory changes after MRC_DONE. Configuration options: [Enabled] [Disabled] Reset for MRC Failed Reset system after MRC training is failed. Configuration options: [Enabled] [Disabled] MRC Training on Warm Boot When enabled, memory training will be executed when warm boot. Configuration options: [Auto] [Enabled] [Disabled] 48