Acer Ferrari 3000 Ferrari 3000 Service Guide - Page 44

Advanced The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced settings of the system. PhoenixBIOS Setup Utility Information Main Advanced Security Boot Exit Parallel port: Mode: Base I/O address: Interrupt: DMA channel [Enabled] [Bi-direct] [378] [IRQ 7] [DMA3] Item Specific Help Configure Infrared Port using options: [Auto] Disable the touchpad if an external PS/2 mouse is connected. Otherwise enable the touchpad [Both] The touchpad is always enabled. Any external PS/2 mouse connected will be enabled at the same time. F1 Help Esc Exit ↑ ↓ Select Item ← → Select Menu F5/F6 Change Values Enter Select 4 Sub- Menu F9 Setup Defaults F10 Save and Exit The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings. Parameter Serial Port Parallel Port Mode Base I/O address Interrupt DMA channel Description Options Enables, disables or auto detects the serial port. Enabled/Disabled/Auto Enables, disables or auto detects the parallel port. Enabled/Disabled/Auto Sets the operation mode of the parallel port. ECP, EPP, Normal or Bi-directional Sets the I/O address of the parallel port. This parameter is enabled only if Mode is set to ECP or Bi-directional. This parameter is enabled only if Mode is set to ECP. 378h/278h/3BCH Sets the interrupt request of the parallel port. IRQ7/IRQ5 Sets a DMA channel for the printer to operate in DMA3/DMA1 ECP mode. This parameter is enabled only if Mode is set to ECP. 36 Chapter 2