Acer P1203PB User Manual (Networking) - Page 49
Troubleshooting
View all Acer P1203PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
49 English Troubleshooting If you experience a problem with your Acer projector, refer to the following troubleshooting guide. If the problem persists, please contact your local reseller or service center. Problems and Solution # Problem Solution 1 The projector stops If possible, turn off the projector, then unplug responding to all the power cord and wait at least 30 seconds controls before reconnecting power. 2 Lamp burns out or When the lamp reaches the end of its useful life, makes a popping it will burn out and may make a loud popping sound sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the Replacing the Lamp section of your projector's manual. 3 Image or projector Please refer to the troubleshooting section in problems your projector's manual. 4 Unable to read the Please make sure the USB device is in good USB device condition and properly inserted. Remember that the projectors do not support file formats other than FAT16/32. 5 USB drive fail USB port does not support USB hub function and which power consumption is over 500mA. 6 Media file not found or can't be opened from the file list Files that require a CODEC that is not supported won't be shown in the file list. Please check the list of media formats supported.