Acer TravelMate 4730 TravelMate 4730/4730G Service Guide - Page 37

Main The Main screen allows the user to set the system time and date as well as enable and disable boot option and recovery. Information Main System Time System Date Total Memory Video Memory InsydeH20 Setup Utility Advanced Security Power Boot [13:04:04] [06/04/2008] 4095 MB [256MB] Rev. 3.5 Exit Item Specific Help This is the help for the hour field. Valid range is from 0 to 23. INCREASE/REDUCE : F5/F6 Quick Boot Network Boot F12 Boot Menu D2D Recovery SATA Mode [Enabled] [Enabled] [Enabled] [Enabled] [AHCI] F1 Help ESC Exit ↑↓ Select Item ←→ Select Menu F5/F6 Change Values Enter SelectXSubMenu F9 Setup Default F10 Save and Exit NOTE: The screen above is for your reference only. Actual values may differ. The table below describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings. Parameter System Time System Date Total Memory Video Memory Quick Boot Network Boot F12 Boot Menu D2D Recovery SATA Mode Description Sets the system time. The hours are displayed with 24hour format. Sets the system date. This field reports the memory size of the system. Memory size is fixed to 3017 MB. Shows the video memory size. VGA Memory size=32 MB Allows startup to skip certain tests while booting, decreasing the time needed to boot the system. Enables, disables the system boot from LAN (remote server). Enables, disables Boot Menu during POST. Enables, disables D2D Recovery function. The function allows the user to create a hidden partition on hard disc drive to store operation system and restore the system to factory defaults. Control the mode in which the SATA controller should operate. Format/Option Format: HH:MM:SS (hour:minute:second) Format MM/DD/YYYY (month/day/year) N/A N/A Option: Enabled or Disabled Option: Enabled or Disabled Option: Enabled or Enabled Option: Enabled or Disabled Option: AHCI or IDE Mode NOTE: The sub-items under each device will not be shown if the device control is set to disable or auto. This is because the user is not allowed to control the settings in these cases. Chapter 2 27