Adaptec 2020SA User Guide - Page 46
Installing the NetWare Driver, Installing the Driver When You Install NetWare
UPC - 760884145289
View all Adaptec 2020SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Installing the Driver 3 Turn on the computer, then insert the driver disk. 4 To run the pkgadd utility, type pkgadd -d diskette1 and then press Enter. UNIX reads the disk and package information. 5 Press Enter. 6 Restart the computer. The system rebuilds the kernel automatically. 7 Add devices created on the RAID controller to the operating system. For details, refer to your OpenServer documentation. Installing the NetWare Driver This section contains the following procedures: ■ Installing the Driver When You Install NetWare on page 3-9 ■ Installing the Driver in an Existing NetWare System on page 3-10 ■ Loading NetWare Drivers During Server Restart on page 3-11 Installing the Driver When You Install NetWare To install the driver with the operating system during a fresh install: 1 Install and configure the controller and hard drives, as described in page 2-3. 2 Create the bootable array, as described on page 2-5. 3 Create the driver disk, as described on page 3-2. When finished, remove the driver disk. 4 Restart the computer, then press Ctrl+A when prompted to access the ARC utility. Use ARC to create the RAID. For details, see Using the Adaptec RAID Configuration (ARC) Utility on page 2-6. 5 Install and configure a secondary controller, if any. 6 Create the driver disk, as described on page 3-2. When finished, remove the driver disk. 7 Install the operating system according to the NetWare documentation. Verify that you have the aacraid.ham and aacraid.ddi files available on the driver disk created at the beginning of this chapter. 3-9