Adaptec 51645 User Guide - Page 57
Installing on OpenServer, Installing on UnixWare, Installing on Solaris
UPC - 760884155622
View all Adaptec 51645 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Chapter 8: Installing the Driver on an Existing Operating System ● 57 Installing on OpenServer To install the driver on OpenServer: 1 Start your computer, then insert the driver disk. 2 Begin the driver package installer: pkgadd -d diskette1 3 At the installer prompt, type go. 4 Select 1 for the aacraid package. 5 When the installation is complete, select q to quit the installer. 6 Reboot your computer and remove the driver disk. 7 Continue with Managing Your Storage Space on page 59. Installing on UnixWare To install the driver on UnixWare: 1 Start your computer, then insert the driver disk. 2 Begin the driver package installer: pkgadd -d diskette1 3 At the installer prompt, type go. 4 Select 1 for the aacraid package. 5 When the installation is complete, select q to quit the installer. 6 Reboot your computer and remove the driver disk. 7 Continue with Managing Your Storage Space on page 59. Installing on Solaris To install the driver on Solaris: 1 Start your computer. 2 Check for any pre-existing Adaptec driver by performing a pkginfo SUNWaac in a terminal window. If there is no pre-existing Adaptec driver on your computer, continue with Step 3. If an Adaptec driver is already installed on your computer, perform a pkgrm SUNWaac to remove it. ! Caution: If your operating system currently boots from the Adaptec controller, do not reset your computer after you remove the pre-existing Adaptec driver. Instead, follow the steps in this section to install a new driver before rebooting your computer. 3 Insert and mount the driver disk: volcheck 4 Change to the driver installer directory: cd /floppy/floppy0/DU/sol_210/i86pc/Tools