Amana ACR4503SFB Owners Manual - Page 12
Electrical Connection Options, Wire Connection: Power Supply Cord, Style 2: Direct wire strain relief
View all Amana ACR4503SFB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
� Tighten strain relief screw against the power supply cord. If your home has: And you will be connecting to: Go to Section: 3-wire receptacle (NEMA type 10-50R A UL Listed, 250 V minimum, 40 A, range power supply cord 3-wire connection: Power supply cord Style 2: Direct wire strain relief � Remove the knockout as needed for the flexible conduit connection. � Assemble a UL listed conduit connector in the opening. 3-wire direct A circuit breaker box or fused disconnect 3-wire connection: Direct wire A. Removable retaining nut B. Conduit � Tighten strain relief screw against the flexible conduit. 4-Wire Connection: Power Supply Cord Use this method for: � New branch-circuit installations (1996 NEC) � Mobile homes � Recreational vehicles � In an area where local codes prohibit grounding through the neutral 1. Part of metal ground strap must be cut out and removed. 5. Complete installation following instructions for your type of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is not available) Electrical Connection Options If your home has: And you will be connecting to: Go to Section: 4-wire receptacle (NEMA type 14-50R) A UL Listed, 250 V minimum, 40 A, range power supply cord 4-wire connection: Power supply cord A. Metal ground strap B. Discard C. Ground-link screw 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw. 3. Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block. 4-wire direct 12 A circuit breaker box or fused disconnect 4-wire connection: Direct wire A. Terminal block C. UL listed strain relief B. Ground-link screw D. Power supply cord wires 4. Use Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the ground-link screw. The ground wire must be attached first.