Amana AGR5330BAB Installation Guide - Page 16

Complete Conversion

Get Amana AGR5330BAB PDF manuals and user guides View all Amana AGR5330BAB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

NOTE: The range cooktop is equipped with 4 burners: 1 burner is power (left front), 2 burners are standard (right front and left rear), and 1 burner is simmer (right rear). 3. Locate Natural gas orifice spud stamped "47" in the bag containing literature supplied with the range. 4. Use a ³⁄8" combination wrench and remove the LP gas orifice spud. 5. Install the number "47" Natural gas spud. A A. Standard burner - Natural gas orifice spud number 149 B. Power burner - Natural gas orifice spud number 165 C. Simmer burner - Natural gas orifice spud number 110 D. Standard burner - Natural gas orifice spud number 149 5. Place LP gas orifice spuds in the parts bag for future use and keep with the bag containing literature. 6. Reinstall burners, burner caps and burner grates. To Convert Oven Burner 1. Open the oven door and remove oven racks and oven tray with flame spreader, and set aside. 2. Remove screw from the oven burner. Lift oven burner and pull the burner toward you. The orifice spud is behind the oven burner air shutter. A B C A. Oven burner B. Air shutter C. Screw A. Natural gas oven orifice spud stamped with "47" IMPORTANT: Do not overtighten. 6. Place LP gas oven burner spud in plastic parts bag along with LP gas cooktop burner spuds for future use and keep with the bag containing literature. 7. Reinstall oven burner. 8. Reinstall oven racks, oven tray, and flame spreader. Complete Conversion 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Turn the manual shut-off valve in the gas supply line to the open position. 3. Refer to the "Electronic Ignition System" section for proper burner ingestion, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the LO setting for each cooktop burner. Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame ¼" to ½" (0.64 cm to 1.3 cm) long. The outer cone is not as distinct as the inner cone. Natural gas flames do not have yellow tips. 4. Close the broiler door and press the Cancel/Off pad. 5. Refer to the "Complete Installation" section to complete this procedure. W10860789A © 2016. All rights reserved. 1/16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
NOTE:
The range cooktop is equipped with 4 burners: 1 burner
is power (left front), 2 burners are standard (right front and left
rear), and 1 burner is simmer (right rear).
A. Standard burner - Natural gas orifice spud number 149
B. Power burner - Natural gas orifice spud number 165
C. Simmer burner - Natural gas orifice spud number 110
D. Standard burner - Natural gas orifice spud number 149
5.
Place LP gas orifice spuds in the parts bag for future use
and keep with the bag containing literature.
6.
Reinstall burners, burner caps and burner grates.
To Convert Oven Burner
1.
Open the oven door and remove oven racks and oven tray
with flame spreader, and set aside.
2.
Remove screw from the oven burner. Lift oven burner and
pull the burner toward you. The orifice spud is behind the
oven burner air shutter.
A. Oven burner
B. Air shutter
C. Screw
3.
Locate Natural gas orifice spud stamped “47” in the bag
containing literature supplied with the range.
4.
Use a ³⁄
8
" combination wrench and remove the LP gas
orifice spud.
5.
Install the number “47” Natural gas spud.
A. Natural gas oven orifice spud stamped with “47”
IMPORTANT:
Do not overtighten.
6.
Place LP gas oven burner spud in plastic parts bag along
with LP gas cooktop burner spuds for future use and keep
with the bag containing literature.
7.
Reinstall oven burner.
8.
Reinstall oven racks, oven tray, and flame spreader.
Complete Conversion
1.
Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
2.
Turn the manual shut-off valve in the gas supply line to the
open position.
3.
Refer to the “Electronic Ignition System” section for proper
burner ingestion, operation, and burner flame adjustments.
IMPORTANT:
You may have to adjust the LO setting for each
cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame ¼" to ½" (0.64 cm to 1.3 cm) long. The outer cone
is not as distinct as the inner cone. Natural gas flames do not
have yellow tips.
4.
Close the broiler door and press the Cancel/Off pad.
5.
Refer to the “Complete Installation” section to complete
this procedure.
W10860789A
© 2016. All rights reserved.
1/16
B
A
C
A