Asko D3531 User manual D3531 Use & Care Guide EN - Page 8
Display, Type of Fault and Recommended Action - water inlet fault
View all Asko D3531 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
OPTIONS, CONTINUED Drying This lets you select how long the turbo fan runs after the final rinse. You have three options: Short, Economy or Normal drying. (Note: This option is not available with the Auto wash, Rinse and Hold, and Rinse and Dry programs.) To set the drying time, press Menu until "Drying" displays, then press Set until your preference displays. Express This option reduces the wash time and lowers the wash temperature by 20° F. (Note: This option is not available with the Quick Wash and Rinse and Hold/Dry Programs.) Press Menu until Express displays, then press Set once to select On or twice to select Off. Press Menu to confirm your selection. Super rinse The Super rinse option adds two extra rinses. This gives an even better rinsing result. The Super rinse option can be used in all programmes except the Auto wash, Quick wash and Rinse & Dry/Hold programmes. Press Menu until Super rinse displays, then press Set once to select On or twice to select Off. Press Menu to confirm your selection. Cool Touch This option lets you set a cool-down cycle after the drying program. Press Menu until Cool Touch displays, then press Set once to select On or twice to select Off. Press Menu to confirm your selection. PROGRAM TIMES The program times may not always be the same because of variations in the household hot water temperature. The dishwasher heats the water to the proper temperature for the program selected; so if the temperature of the water entering the dishwasher is too low, the dishwasher will run longer because it takes longer to heat the water. Raising your water heater setting could help to shorten the cycle times. INTERRUPTING A PROGRAM TO ADD AN ITEM If you want to interrupt a program to add an item, open the door slightly until the spray arms stop turning. You can then open the door fully and place the item into the dishwasher. Close the door securely. The program will continue from where it was interrupted. WARNING! Be extremely careful when opening the door during a program. The water is hot and you could get scalded. CHANGING OR STOPPING A PROGRAM If you decide to change the program after you have started the machine, press the Start/Stop button for three seconds. You will have to select the program and options again when you are ready to restart the program. (Note: If the program has already gone through the wash cycle, you will have to add detergent.) POWER BUTTON Use this button to turn the main power to the unit on and off. The location of the power button is illustrated on page 7. START/STOP BUTTON Once you have selected the wash program and options, press this button to start the dishwasher. (Make sure the door is securely closed.) FAULT CODES In the event that the machine should fail during a program, the display window will show a fault code. The table below defines these codes and gives possible causes and solutions. See also "Troubleshooting" on page 13. If you have corrected the fault, turn the main power off then back on to remove the fault indication. If it still displays, try again to correct the problem or call a service technician. Display Overfilling Water Inlet Fault Inlet Valve Leakage Drainage Blocked Filter Type of Fault and Recommended Action Too much water has entered the dishwasher. Call a service technician. Water inlet fault. Make sure the water supply is open. Valve leakage. Shut off the water supply and contact a service technician. The drain is blocked. See "Troubleshooting" on page 13. The filter is clogged. See "Cleaning the Filters" on page 10. Page 8 Customer Care Center 1-800-898-1879 www. askousa.com