Asko T411VDT Installation Instructions English - Page 8
Closet Install- Ventilation Requirements
View all Asko T411VDT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
BUILT-IN 4-1/2" 8-3/4" 115 mm 222 mm Closet Install- Ventilation Requirements ASKO's front panel controls make it possible to install the washers and dryers in a closet. Make sure there is clearance between units and cabinet or wall and a 1" (25 mm) minimum clearance between the rear edge of the machine top panel and the cabinet or wall. To ensure proper ventilation, we recommend louvered doors. Otherwise there must be ventilation openings in the door. See illustration for minimum ventilation openings below (gray boxes): 77030m-1m/3" ASKO dryers can be installed beneath a cabinet or worktop with a minimum height of 34" (864 mm). There must be a gap of about 1/2" (12 mm) all around the machine, including between the rear edge of the machine and the back wall. The opening width must be at least 24-1/2" (622 mm). The height adjustment for the dryer is 33-1/2" to 34-1/2" (850 mm to 876 mm). Do not raise it higher than 34-1/2" (876 mm). Hole measurements are from center of hole. Ensure the dryer door can be opened without hindrance after installation. The cool air intake panel at the front of the dryer must not be blocked or covered. Doing so could cause an error. 8 Customer Care Center, 1-800-898-1879, www.askona.com