Asko T411VDW Use and Care Guide English - Page 37

Problem/error Cause What to do? Laundry not dried or drying takes too long. • Filters are not clean. • Dryer is placed in a closed room; room that is too cold; or room that is too small and the air overheats as a result. • Clean the filters (see chapter "CLEANING AND MAINTENANCE"). • Make sure there is adequate supply of fresh air to the dryer; for example, open the door and/or window. • Check if the temperature in the room where the dryer is installed is too high or too low. • Laundry was not sufficiently wrung or spun. • If the load is still wet after completed drying cycle, an appropriate drying program should be run again (after cleaning filters). • Amount of laundry dried in the appliance is too large or insufficient. • Use a suitable program or extra functions. • Laundry (such as bedding) gets tangled. • Close the buttons or zippers on the laundry before drying. Select a suitable program (e.g. the bedding program). • After the drying process, loosen the laundry and select an additional drying program (e.g. timed drying program). Unevenly dried laundry. • Laundry of varying types and thickness, and excessive amount of laundry. • Make sure you have sorted the laundry by type and thickness, whether you have added a suitable amount of laundry to the drum, and whether you have selected a suitable program. A slight hitting noise appears. • If the dryer is out of use for a long period of time, the same points of load-bearing elements or components are under stress for a long time, causing temporary deformation. • The noise will subside without any intervention. The door opens during drying. • Excessive load on the door (too much laundry in the drum). • Reduce the amount of laundry. Customer Care Center, 1-800-898-1879, www.askona.com 37