Asus K8V-VM GREEN K8V-VM user's manual - Page 31
ASUS K8V-VM Motherboard, IDE connectors 40-1 pin PRI_IDE, SEC_IDE
View all Asus K8V-VM GREEN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE) The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device(s). Drive jumper setting Single device Cable-Select or Master Two devices Cable-Select Master Slave Mode of devices Cable connector - Black Master Black Slave Gray MSlaasvteer Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. K8V-VM PRI_IDE SEC_IDE R r K8V-VM IDE Connector ASUS K8V-VM Motherboard 1-21