Asus M3N-HT Deluxe Mempipe User Manual - Page 63
NVIDIA, nForce 780a SLI Serial ATA connectors, Serial ATA connectors, pin SATA1-4 [red]; 7-pin SATA5 - nvidia nforce 780a sli
View all Asus M3N-HT Deluxe Mempipe manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
3. NVIDIA® nForce 780a SLI�S���e��r��i�a���l��A���T��A����c��o���n���n��e�c��to��rs� (7-pin SATA1-4 [red]; 7-pin SATA5-6 [black]) These connectors are for the Serial ATA signal cables for Serial ATA hard disk and optical disk drives. If you install SATA hard disk drives to the SATA1/2/3/4/5/6 connectors, you can create a RAID 0, RAID 1, RAID 0+1, RAID 5 and JBOD configuration through the onboard NVIDIA® nForce 780a SLI controller. • SATA1-4 connectors are set to [IDE] by default. If you intend to create a Serial ATA RAID set using these connectors, set the Onchip SATA Type item in the BIOS to [RAID]. • Before creating a RAID set, refer to the manual bundled in the motherboard support DVD. • SATA 5-6 connectors support AHCI mode and RAID mode only. Make sure to install the AHCI driver or RAID driver in the bundled support DVD before connecting devices to SATA 5-6 connectors. Otherwise, the devices will not work. • Due to chipset limitation, when you set any of the SATA ports to RAID mode, all SATA ports run at RAID mode simultaneously. • You must install the Windows® XP Service Pack 1 before using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0 and RAID 1) is available only if you are using Windows® XP or later version. Connect the right-angle side of SATA signal cable to SATA device. Or you may connect the right-angle side of SATA cable to the onboard SATA port to avoid mechanical conflict with huge graphics cards. right angle side ASUS M3N-HT Deluxe Series 2-37