Asus P3V133 P3V133 User Manual - Page 37
ASUS P3V133 User's Manual, Wake-On-LAN Connector 3-pin WOL_CON, Wake-On-LAN, IrDA-Compliant Infrared
View all Asus P3V133 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
3. H/W SETUP Connectors 3. HARDWARE SETUP 11. Wake-On-LAN Connector (3-pin WOL_CON) The WOL_CON connector powers up the system when a wake-up packet or signal is received from the network through an optional PCI-L101 LAN card. IMPORTANT: This feature requires that the Wake-On-LAN Power Up Control is set to Enabled (see Power Management Setup under BIOS SETUP) and that your system has an ATX power supply with at least 720mA +5V standby power. WOL_CON Ground +5 Volt Standby (No Connection) P3V133 R P3V133 Wake on LAN Connector 12. IrDA-Compliant Infrared Module Connector (5-pin IR) This connector supports the optional wireless transmitting and receiving infrared module. This module mounts to a small opening on system cases that support this feature. You must also configure the setting through "UART2 Use Infrared" in Chipset Features Setup to select whether UART2 is directed for use with COM2 or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable from the module to the motherboard according to the pin definitions. +5V IRRX IRTX (NC) GND P3V133 R P3V133 Infrared Module Connector Front View Back View IRTX +5V GND FIRRX IRRX For the infrared feature to be available, you must connect the optional Infrared (IrDA) module to the motherboard. ASUS P3V133 User's Manual 37