Asus P5B-VM SE P5B-VM English Edition User's Manual - Page 45
JMicron JMB363 - ahci
View all Asus P5B-VM SE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
P5B-VM R 4. JMicron JMB363® Serial ATA RAID connector (7-pin SATA_RAID) This connector is for a Serial ATA signal cable. This connector supports a Serial ATA hard disk drive that you can configure for RAID through the onboard Serial ATA RAID controller. The JMicron controller mode item in the BIOS is set to [AHCI] by default, allowing you to use the connectors to build a RAID set. See section "2.4.5 Onboard Device Configuration" for details. SATA_RAID1 GND RSATA _RXN1 RSATA _RXP1 GND RSATA _TXN1 RSATA _TXP1 GND P5B-VM SATA RAID Connector Before creating a RAID set using Serial ATA hard disks, make sure that you have connected the Serial ATA signal cables and installed Serial ATA hard disk drives; otherwise, you cannot enter the JMicron® JMB363 RAID utility and SATA BIOS setup during POST. 5. IEEE 1394a port connector (10-1 pin IE1394_2) This connector is for a IEEE 1394a port. Connect the IEEE 1394a module cable to this connector, then install the module to a slot opening at the back of the system chassis. P5B-VM R TPA1GND TPB1+12V GND TPA1+ GND TPB1+ +12V IE1394_2 P5B-VM IEEE 1394a Connector 1 The IEEE 1394a module is purchased separately. ASUS P5B-VM 1-33