Asus P5E3 Premium WiFi-APn User Manual - Page 54
IDE connector 40-1 pin PRI_E IDE, P5E3 Premium/WiFi-AP @n, IDE connector
View all Asus P5E3 Premium WiFi-APn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
2. IDE connector (40-1 pin PRI_E IDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. ® P5E3 PREMIUM PRI_EIDE NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. P5E3 Premium/WiFi-AP @n IDE connector Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. 2-28 Chapter 2: Hardware information