Asus P5G41-M LE User Manual - Page 36
P5G41-M LE IDE connector
View all Asus P5G41-M LE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
3. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 100/66/33 signal cable. There are three connectors on each Ultra DMA 100/66/33 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) - Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices. PRI_IDE PIN1 P5G41-M LE NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. P5G41-M LE IDE connector If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. 1-26 Chapter 1: Product introduction