Asus P5K-E WiFi-AP User Manual - Page 54
Serial ATA hard disk drive connection, Configure SATA as, 3.6 SATA Configuration
View all Asus P5K-E WiFi-AP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
• You must install the Windows® XP Service Pack 1 or later version before using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0, RAID 1, RAID 5, and RAID 10) is available only if you are using Windows® XP or later version. • When using the connectors in Standard IDE mode, connect the primary (boot) hard disk drive to the SATA1/2/5 connector. Refer to the table below for the recommended SATA hard disk drive connections. Serial ATA hard disk drive connection Connector SATA1/2/5/6 SATA3/4 Color Red Black Setting Master Slave Use Boot disk Data Disk Connect the right-angle side of SATA signal cable to SATA device. Or you may connect the right-angle side of SATA cable to the onboard SATA port to avoid mechanical conflict with huge graphics cards. right angle side When using hot-plug and NCQ, set the Configure SATA as in the BIOS to [AHCI]. See section 4.3.6 SATA Configuration for details. 2-28 Chapter 2: Hardware information