Asus P5ND2-SLI Deluxe P5ND2-SLI Series User''s Manual for English Edition - Page 27
Before you proceed
View all Asus P5ND2-SLI Deluxe manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
2.1 Before you proceed Take note of the following precautions before you install motherboard components or change any motherboard settings. • Unplug the power cord from the wall socket before touching any component. • Use a grounded wrist strap or touch a safely grounded object or to a metal object, such as the power supply case, before handling components to avoid damaging them due to static electricity. • Hold components by the edges to avoid touching the ICs on them. • Whenever you uninstall any component, place it on a grounded antistatic pad or in the bag that came with the component. • Before you install or remove any component, ensure that the ATX power supply is switched off or the p o w e r c o r d i s d e t a c h e d f r o m t h e p o w e r s u p p l y . Failure to do so may cause severe damage to the motherboard, peripherals, and/or components. Onboard LED The motherboard comes with a standby power LED. The green LED lights up to indicate that the system is ON, in sleep mode, or in softoff mode. This is a reminder that you should shut down the system and unplug the power cable before removing or plugging in any motherboard component. The illustration below shows the location of the onboard LED. The red warning LED lights up when you installed two graphics card but did not connect the ASUS EZ Plug™. The illustration below shows the location of the onboard LEDs. WARN_LED P5ND2-SLI ON OFF When use 2 Graphics When use 2 Graphics but do not plug EZ-PLUG but do plug EZ-PLUG SB_PWR ® P5ND2-SLI Series Onboard LED ON Standby Power OFF Powered Off Make sure to connect the EZPlug when using two PCI Express graphics cards and a 20-pin ATX power supply unit. ASUS P5ND2-SLI Series 2-1