Asus P5Q-E WiFi-AP User Manual - Page 61
Chassis intrusion connector 4-1 pin CHASSIS, Serial port connector 10-1 pin COM1
View all Asus P5Q-E WiFi-AP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
9. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. 10. Serial port connector (10-1 pin COM1) This connector is for a serial (COM) port. Connect the serial port module cable to this connector, then install the module to a slot opening at the back of the system chassis. ASUS P5Q-E Series 2-35