Asus P5V-VM DH P5VD2-MX/P5V-VM DH English Edition User''s Manual - Page 46
cable to this connector. The chassis intrusion sensor or switch sends
View all Asus P5V-VM DH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
GND PRESENCE# SENSE1_RETUR SENSE2_RETUR AGND NC NC NC MIC2 MICPWR Line out_R NC Line out_L PORT1 L PORT1 R PORT2 R SENSE_SEND PORT2 L 11. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports either High Definition Audio or legacy AC '97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. Azalia-compliant pin definition Legacy AC'97-compliant pin definition ® AAFP Analog front panel connector • Use a chassis that provides a high-definition audio front panel audio I/O to use the high-definition audio features. • The default setting of this connector is legacy AC'97 audio, if you want to use the High-Definition (Azalia) audio features, set the F r o n t P a n e l S u p p o r t T y p e in the BIOS to Azalia. 12. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. +5VSB_MB Chassis Signal GND CHASSIS ® 1-34 Chassis intrusion connector (Default) Chapter 1: Product introduction