Asus P5WDG2-WS PRO P5WDG2 WS Professional English Edition User's Manual - Page 59
ICH7R Serial ATA connectors 7-pin SATA1 [red]
View all Asus P5WDG2-WS PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Single device Two devices Drive jumper setting Mode of device(s) Cable-Select or Master - Cable-Select Master Slave Master Slave Master Slave Cable connector Black Black Gray Black or gray If any device jumper is set as "Cable-Select," make sure all other device jumpers have the same setting. 3 . ICH7R Serial ATA connectors (7-pin SATA1 [red], SATA2 [red], SATA3 [black], SATA4 [black]) These connectors are for Serial ATA signal cables for Serial ATA hard disk drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 10, and RAID 5 configuration with the Intel® Matrix Storage Technology through the onboard Intel® ICH7R RAID controller. • These connectors are set to S t a n d a r d I D E mode by default. In S t a n d a r d I D E mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the C o n f i g u r e S A T A A s item in the BIOS to [RAID]. See section "4.3.6 IDE Configuration" for details. • For RAID 5, use at least three hard disk drives. For RAID 10, use at least four hard disk drives. Use two to four Serial ATA hard disk drives for each RAID 0 or RAID 1 set. P5WDG2-WS PRO GND SATA_RXP2 SATA_RXN2 GND SATA_TXN2 SATA_TXP2 GND GND SATA_RXP3 SATA_RXN3 GND SATA_TXN3 SATA_TXP3 GND ® SATA4 P5WDG2-WS PRO SATA connectors SATA2 ASUS P5WDG2 WS Professional GND SATA_RXP1 SATA_RXN1 GND SATA_TXN1 SATA_TXP1 GND SATA3 SATA1 GND SATA_RXP0 SATA_RXN0 GND SATA_TXN0 SATA_TXP0 GND 2-33