Asus P7H55-M PLUS User Manual - Page 24
P7H55-M LE IDE connector
View all Asus P7H55-M PLUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
9. IDE connector (40-1 pin PRI_EIDE) (for P7H55-M LE only) The onboard IDE connector is for Ultra DMA 100/66 signal cable. There are three connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your devices: Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) - Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices. If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the same setting. PRI_EIDE P7H55-M LE PIN1 NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. P7H55-M LE IDE connector 1-15 Chapter 1: Product introduction