Asus P8P67 LE User Manual - Page 41
P8P67 LE IDE connector
View all Asus P8P67 LE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3. IDE connector (40-1 pin PRI_EIDE) The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices. PRI_EIDE P8P67 LE PIN1 NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. P8P67 LE IDE connector If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. Chapter 1: Product introduction 1-29