Asus RP-AX58 QSG Quick Start Guide - Page 1

Quick Start Guide RP-AX58 AX3000 Dual-Band WiFi Range Extender LED Explanations WiFi Range Extender Mode Status LED Behavior Booting up Blinking White Booting Router) up complete (not connected to Solid Blue Reset (use a pin to press the reset button for 5 seconds) Blinking Yellow Rescue mode Solid Purple Starting WPS Connected to the router with Good Signal Connected to the router with Weak Signal Blinking Blue Solid White Solid Yellow No Signal AP mode (with wired connection) AP mode (without wired connection) Solid Red Solid White Solid Red BEFORE SETUP WE SUGGEST... Hardware Explanations 1 Plug RP-AX58 into a power outlet. 2 The LED will start breathing white for 3 seconds while booting up. Button Explanations LED WPS button reset button LAN port WPS BUTTON Launch the WPS Wizard. RESET BUTTON Reset the system to its factory default settings. LAN PORT Connect your PC to the LAN port with a network cable. AiMesh Mode Status LED Behavior Booting up Blinking White Booting up complete AiMesh Router) (not connected to Solid Blue Reset (use a pin to press the reset button for 5 seconds) Blinking Yellow Rescue mode Solid Purple Connecting to the AiMesh Router Blinking Blue Connected to the AiMesh Router with Good Signal Solid White Connected to the AiMesh Router with Weak Signal Solid Yellow No Signal Ethernet backhaul Solid Red Solid White 01 Placing your RP-AX58 1 Plug your RP-AX58 into a power outlet near your router/AP. 2 Check the LEDs and see the LED explanations. 3 Wait for the LED to flash and turn solid blue, indicating that your RP-AX58 is ready to connect to your existing router/AP. around 2 meters NOTES: • To minimize interference, keep the routers away from devices like cordless phones, Bluetooth devices and microwave ovens. • We recommend that you place the routers in an open or spacious location. SETUP METHODS Set up RP-AX58 as a WiFi range extender If you would like to connect RP-AX58 to other WiFi networks excluding AiMesh-supported routers, please download the ASUS Extender App or set up with the WPS button. METHOD 1 METHOD 2 Download the ASUS Extender App and follow the onscreen instructions Connect via WPS 1  Press the WPS button on your router/ AP. 2  Press the WPS button on your RP-AX58 for more than two (2) seconds until the LED starts to blink blue.