Asus RS100-E6 PI2 User Manual - Page 36
Cable connections, Standard cables connected to the motherboard
View all Asus RS100-E6 PI2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
2.6 Cable connections • The bundled system cables are pre-connected before shipment. You do not need to disconnect these cables unless you will remove pre‑installed components to install additional devices. • Refer to Chapter 4 for detailed information on the connectors. 1 3 2 3 3 4 56 Standard cables connected to the motherboard 1. 24-pin ATX power connector (from power supply to motherboard) 2. 8-pin ATX 12V power connector (from power supply to motherboard) 3. System fan connector (from system fan to motherboard) 4. SATA conectors (system default; from motherboard to SATA devices) 5. USB connector (from motherboard to front I/O board) 6. System panel connectors (from motherboard to front I/O board) 2-18 Chapter 2: Hardware setup
Chapter 2:
Hardware setup
2-18
2.6
Cable connections
•
The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
•
Refer to Chapter 4 for detailed information on the connectors.
Standard cables connected to the motherboard
1.
24-pin ATX power connector (from power supply to motherboard)
2.
8-pin ATX 12V power connector (from power supply to motherboard)
3.
System fan connector (from system fan to motherboard)
4.
SATA conectors (system default; from motherboard to SATA devices)
5.
USB connector (from motherboard to front I/O board)
6.
System panel connectors (from motherboard to front I/O board)
3
2
1
4
5
3
3
6